Gen7 Endstop 1.0/1.1 is the intitial version in the development of Gen7 Endstop. Circuitry was close to the one of RepRap's Generation 3 Electronics, but it was redesigned for DIY-ablility of the PCB.
For the most recent version, see Gen7 Endstop v1.3.1.
As this is no longer the newest version and is based on a part no longer available, you're pretty much on your own to make one. Best bet is to look up the releases folder of the release-1.1 branch on the Git repository.
Traumflug can do custom PCBs quickly, so if you offer him a beer or something, chances are good to get a couple of boards.
-==-
Name | Count | Designations | Remarks |
---|---|---|---|
Resistor 220 Ohms | 1 | R1 | |
Resistor 1 kOhms | 1 | R3 | |
Resistor 10 kOhms | 1 | R3 | |
LED 3 mm Red | 1 | LED1 | |
Photointerrupter H21LOB | 1 | U1 | “End of life”, no vendor known, you might have luck at eBay. |
Molex KK100 3-Pin Header | 1 | CONN1 | |
Cable Connector for the above | 1 | ||
Crimp Contact for the above | 3 |
TBD